Equipment Configurations
click forlarger version
Vertical shredders are ideally suited for use in printing and box plants for signature waste, roll strippings, die cuttings, sheet waste and for book and magazine destruction. When equipped with an optional metering conveyor, the unit becomes self-feeding under many conditions. This permits the operator to load material on the conveyor and leave for other duties, or to pick up another load.
click forlarger versionInnovative Features
High level discharge monitor
Should "back-up" occur in baler feed chute, monitor stops shredder feed conveyor until level drops to operating point. System feed conveyor then automatically restarts.Dual function loadmeter sensor
Controls water mist system. Used to improve baleability of some materials. Monitors shredder motor current. Relay actuates water mist solenoid valve only when level exceeds preset (no load) condition. Sensor is also used to cycle feed belt on and off as shredder approaches full load to help prevent overloading.Box crusher
Recommended when majority of boxes to be shredder exceed 12" height. Crusher accepts boxes up to 38" high by pre-crushing them to a size that can be accommodated by the shredder configuration.Safety overweight plate
Dual pivotally-mounted conveyor bed treadles are counter-balanced by adjusting coil springs. Whenever loads over 60 to 80 pounds reach this conveyor area, clutch drive is disengaged and shredder motor power is cut.Vacuum filter unit Ultra-sanitary operations, such as in the food industry, pharmaceutical plants, printing operations and electronic manufacturing, require absolute dustless working conditions. A vacuum filter, positioned a top shredder discharge chute, employs a small fan to create a negative pressure throughout the piggy-back system by discharging air up through filter bags, preventing dust escapement.
Bulletin 871
